Castability

Summary

Castability is the ease of forming a quality casting.[1] A very castable part design is easily developed, incurs minimal tooling costs, requires minimal energy, and has few rejections.[2] Castability can refer to a part design or a material property.[1]

Part design edit

Part design and geometry directly affect the castability, with volume, surface area and the number of features being the most important attributes.

If the design has undercuts or interior cavities it decreases castability due to tooling complexity. Long thin sections in a design are hard to fill.[1] Sudden changes in wall thickness reduce castability because it induces turbulence during filling; fillets should be added to avoid this. Annulars in the path of flow should be avoided because they can cause cold shuts or misruns. A design that causes isolated hot spots decreases castability.[3] An ideal design would have progressive directional solidification from the thinnest section to the thickest.[4]

Location of the mold's parting line also affects castability, because a non-planar parting line also increases tooling complexity.

If a design requires a high degree of accuracy, fine surface finish or defect free surface it reduces the castability of the part.[2] However, the casting process can be very economical for part designs that require intricate contoured surfaces, thickness variations, and internal features.[3]

Quantitative analysis edit

The castability of a design can be partially quantitatively determined by the following three equations. Better castability is denoted by a larger number.[3]

 

Where Vc is the volume of the casting and Vb is the volume of the smallest box that the casting could fit in.

 

Where Vc is the volume of the casting and Ac is the surface area of the casting

 

Where nf is the number of features (holes, pockets, slots, bosses, ribs, etc.)

Material properties edit

Material properties that influence their castability include their pouring temperature, fluidity, solidification shrinkage, and slag/dross formation tendencies.[1][5]

See also edit

References edit

Notes edit

  1. ^ a b c d Ravi, p. 1
  2. ^ a b Ravi, p. 2
  3. ^ a b c Ravi, p. 3.
  4. ^ Ravi, p. 4.
  5. ^ Tool and Manufacturing Engineers Handbook (TMEH), 4th Edition, Volume 6, Design for Manufacturability, Society of Manufacturing Engineers, 1992.

Bibliography edit

  • Ravi, B., Design for castability (PDF), IIT Bombay, archived from the original (PDF) on 2006-12-10.