Each coin is formed in a single operation. The press holds two negatives (molds that show each side of the coin) The body (material from which the coin is to be formed) is placed on the lower negative and the upper negative is lowered to create pressure sufficient to emboss the negatives onto the body. The upper negative descends directly without turning, pushed by a threaded bar that rotates, turned by a lever, compensated by an anti-torsion system. It is called a cold deformation as no heat is applied.^[4]

Before the press, coins were minted with a hammer:

After this, the "flam" were distributed to the moneyers to have the impressions put on them. Each moneyer had two irons or puncheons, one of which was called the "pile” and the other the “ Trussell” The "pile” was from seven to eight inches long and was firmly fixed in a block of wood (called "ceppeau ' in the French Ordonnances). On the pile” was engraved one side of the coin, and on the " Trussell,” the other. The “flan "being placed on the “pile" the " Trussell" was applied to the upper side of it by means of a twisted wand, or by the hand, and the moneyer then struck the end of the puncheon with the hammer until the impression was produced on the "flan.^[4]

•  
  General view
•  
  Detall
•  
  Die-mill. Ball radii sometimes measured almost 2 meters (<2m).^[5]
•  
  Nicolas Briot rocking press, c1626.^[6]
•  
  Mint of Cartagena.^[7]