EIAJ_connector Knowpia

The EIAJ connector type, more formally known as EIAJ RC-5320A, is a type of coaxial power connector or jack for small appliances.

Features edit

The entire series of connectors has a built-in retention feature. On types 1, 2, and 3 this involves a bevel on the barrel near the tip, while on types 4 and 5 the tip of the insulator ring has a larger diameter than the metal barrel.

Types edit

The design philosophy is that higher voltages should be supplied via larger plugs to prevent equipment damage. A larger plug will not go into a smaller jack.

Connector Name	Minimum Voltage	Rated Voltage	Rated Current	Outer Diameter	Inner Diameter	Pin Diameter	Shaft Length	Notes
EIAJ-01	0 V	3.15 V	2 A	plug: 2.35 mm jack: 2.75 mm hole	plug: 0.7 mm jack: 0.65 mm pin	none	9.5~13 mm	Philmore 235 plug/205 PCB jack
EIAJ-02	3.15 V	6.3 V	2 A	plug: 4.0 mm jack: 4.4 mm hole	plug: 1.7 mm jack: 1.65 mm pin	none	9.5 mm	Philmore 240 plug/TC240 cord/207 PCB jack
EIAJ-03	6.3 V	10.5 V	2 A	plug: 4.75 mm jack: 5.15 mm hole	plug: 1.7 mm jack: 1.65 mm pin	none	9.5~12 mm	Philmore 275 plug/TC275 cord/220 PCB jack
EIAJ-04	10.5 V	13.5 V	2 A	5.5 mm	3.3 mm	1.0 mm	9.5~13.5 mm	Philmore 255 plug/Philmore 2559 plug
EIAJ-05	13.5 V	18.0 V	2 A	6.5 mm	4.4 mm	1.4 mm	9.5~16 mm	Philmore 265 plug/TC265 cord/214 PCB jack

History edit

This standard was originally created in 1992 as EIAJ RC-6705, updated in 1997, and updated again in 2005.

The Electronic Industries Association of Japan (EIAJ) and the Japan Electronic Industries Development Association have merged to form the Japan Electronics and Information Technology Industries Association (JEITA), an electronics and IT industry trade organization.

ET-2502A edit

The use of these connectors on equipment is defined in JEITA ET-2502A.^[1] For instance, this document describes the interface between a car cigarette plug or RC-5321 plug and the powered device, the polarity symbol used (JEITA CP-1104A),

EIAJ RC-5321 edit

This is a unique-looking barrel connector, apparently intended for providing a DC output jack (most DC jacks are used for power input).

Possibly available in multiple voltage ranges, the one for voltage classification 2 (3.15 to 6.3 V) has an outside diameter of 4.75 mm and a protruding pin of 2.5 mm diameter.

Previously known as EIAJ RCX-5321.

EIAJ RC-5322 edit

According to Hosiden, this is a 12V/24V barrel connector designed for electronic equipment used in cars. The outside diameter is 6.5mm. [1]^{[permanent dead link]}

Previously known as EIAJ RCX-5322.