Limber_hole Knowpia

A limber hole is a drain hole through a frame or other structural member of a boat designed to prevent water from accumulating against one side of the frame, and allowing it to drain toward the bilge.

Limber holes are common in the bilges of wooden boats. The term may be extended to cover drain holes in floors. Limber holes are created in between bulkheads so that one compartment does not fill with water. The limber holes allow water to drain into the lowest part of the bilge so that it can be pumped out by a single bilge pump^[1] (or more usually, one electric and one manual pump).

The term is also commonly applied to the holes in mid-20th century submarine upperworks, which allow drainage from the superstructure.^[2]

References edit

Chapelle, Howard I. (1994, p252). Yacht Designing and Planning. W.W. Norton. ISBN 0-393-03756-8.
Brewer, Ted (1994, p139). Understanding Boat Design (4th ed.). International Marine, a division of McGraw Hill. ISBN 0-07-007694-4.

^ Chisholm, Hugh, ed. (1911). "Limber" . Encyclopædia Britannica. Vol. 16 (11th ed.). Cambridge University Press. p. 691.
^ Polmar, Norman; Moore, Kenneth J. (2005). Cold War Submarines: The Design and Construction of U.S. and Soviet Submarines 1945-2001. Potomac Books. p. xxi. ISBN 978-1574885309.

[1] Chisholm, Hugh, ed. (1911). "Limber" . Encyclopædia Britannica. Vol. 16 (11th ed.). Cambridge University Press. p. 691.

[polmar-2] Polmar, Norman; Moore, Kenneth J. (2005). Cold War Submarines: The Design and Construction of U.S. and Soviet Submarines 1945-2001. Potomac Books. p. xxi. ISBN 978-1574885309.

[1]

[2]

Summary

References edit