Tetranitromethane

Summary

Tetranitromethane or TNM is an organic oxidizer with chemical formula C(NO2)4. Its chemical structure consists of four nitro groups attached to one carbon atom. In 1857 it was first synthesised by the reaction of sodium cyanoacetamide with nitric acid.[4]

Tetranitromethane[1]
Names
IUPAC name
Tetranitromethane
Other names
TNM
Tetan
Identifiers
  • 509-14-8 checkY
3D model (JSmol)
  • Interactive image
ChEMBL
  • ChEMBL261663 checkY
ChemSpider
  • 13842838 checkY
ECHA InfoCard 100.007.359 Edit this at Wikidata
EC Number
  • 208-094-7
KEGG
  • C19300 checkY
  • 10509
RTECS number
  • PB4025000
UNII
  • K1G7CKU98F checkY
UN number 1510
  • DTXSID5021334 Edit this at Wikidata
  • InChI=1S/CN4O8/c6-2(7)1(3(8)9,4(10)11)5(12)13 checkY
    Key: NYTOUQBROMCLBJ-UHFFFAOYSA-N checkY
  • InChI=1/CN4O8/c6-2(7)1(3(8)9,4(10)11)5(12)13
    Key: NYTOUQBROMCLBJ-UHFFFAOYAA
  • C([N+](=O)[O-])([N+](=O)[O-])([N+](=O)[O-])[N+](=O)[O-]
Properties
C(NO2)4
Molar mass 196.04 g/mol
Appearance Colorless to pale-yellow liquid or solid
Odor Pungent
Density 1.623 g/cm3
Melting point 13.8 °C (56.8 °F; 286.9 K)
Boiling point 126 °C (259 °F; 399 K)
insoluble
Vapor pressure 8 mmHg (20°C)[2]
-43.02·10−6 cm3/mol
Hazards
Occupational safety and health (OHS/OSH):
Main hazards
Oxidant, can form explosive mixtures
GHS labelling:
GHS02: FlammableGHS06: ToxicGHS07: Exclamation markGHS08: Health hazard
Danger
H271, H301, H315, H319, H330, H335, H351
P201, P202, P210, P220, P221, P260, P261, P264, P270, P271, P280, P281, P283, P284, P301+P310, P302+P352, P304+P340, P305+P351+P338, P306+P360, P308+P313, P310, P312, P320, P321, P330, P332+P313, P337+P313, P362, P370+P378, P371+P380+P375, P403+P233, P405, P501
NFPA 704 (fire diamond)
Lethal dose or concentration (LD, LC):
18 ppm (rat, 4 hr)
100 ppm (cat, 20 min)
54 ppm (mouse, 4 hr)[3]
NIOSH (US health exposure limits):
PEL (Permissible)
TWA 1 ppm (8 mg/m3)[2]
REL (Recommended)
TWA 1 ppm (8 mg/m3)[2]
IDLH (Immediate danger)
4 ppm[2]
Safety data sheet (SDS) ICSC 1468
Related compounds
Related compounds
Hexanitroethane
Octanitropentane
Trinitromethane
Except where otherwise noted, data are given for materials in their standard state (at 25 °C [77 °F], 100 kPa).
☒N verify (what is checkY☒N ?)
Infobox references

Uses edit

It has been investigated for use as an oxidizer in bipropellant rockets; however, its low melting point makes it unsuitable. Highly purified tetranitromethane cannot be made to explode, but its sensitivity is increased dramatically by oxidizable contaminants, such as anti-freezing additives. This makes it effectively unusable as a propellant.[5] In the laboratory it is used as a reagent for the detection of double bonds in organic compounds and as a nitrating reagent. It has also found use as an additive to diesel fuel to increase the cetane number.[6]

Preparation edit

TNM is a pale yellow liquid that can be prepared in the laboratory by the nitration of acetic anhydride with anhydrous nitric acid (Chattaway's method).[7] This method was attempted on an industrial scale in the 1950s by Nitroform Products Company in Newark, USA, but the entire plant was destroyed by an explosion in 1953.[8]

The first industrial scale production was started in Germany during World War II in an effort to improve the cetane number of diesel fuel. This process improved the original method, which started with acetic acid and nitric acid.[9] Without regard to yield or cost, approximately 10 tons of TNM were produced in a few weeks. However, this production process has not been used again industrially after the end of the war, because of high associated costs.[10]

For commercial use a cheaper method starting from acetylene has been used.[11] First, nitric acid containing mercuric nitrate is reduced by acetylene, resulting in trinitromethane (nitroform) and a mixture of carbon dioxide and nitrogen oxide as waste gas. The nitrogen oxides are valuable and normally recovered as nitric acid in an absorption tower. The resulting nitroform is converted to TNM by adding nitric and sulfuric acid at higher temperatures. With this method a yield of 90% (based on nitric acid) before purification can be reached.[12]

Structure edit

 
Figure 1: Disordered appearance of TNM molecules in the crystalline state

TNM is a prime example of molecular flexibility. It brought structural methods to the limits of their applicability as is shown by the fact that the structure of TNM was attempted to be determined for a period of more than 70 years in various phases.[13]

Early investigations by gas electron diffractions were unable to describe the observed diffraction pattern in full and only the application of a four-dimensional model concerning the correlated movement of the four NO2 groups about the C–N bonds was able to describe the experimental observations fully. The problem occurs, because the two-fold local symmetry of the C−NO2 units versus the three-fold symmetry of the C(NO2)3 unit, as well as the close proximity of the NO2 groups hindering their free rotation, is the source for a very complicated mutually hindered movement of the NO2 groups.

The crystal structure has also been attempted several times. A first decent solution of the problem required a model describing a highly disordered high‐temperature crystalline phase of a high-temperature phase (>174.4 K) as is shown in Figure 1. Reduction of symmetry and analysis of the twinning of the crystals led finally to a resolved disorder of the structure shown in Figure 2.

 
Figure 2: Resolved disorder of the high-temperature phase of TNM

The structure of an ordered low‐temperature phase contains three independent molecules in the asymmetric unit. Structural parameters of the gaseous and solid phases are listed in the following table for comparison.

Structural parameters of TNM determined by gas electron diffraction (GED) and single crystal X-ray diffraction (XRD). Distances are in Å angles in deg.
Parameter GED XRD (range)
rC–N 1.509(5) 1.502(4)  – 1.554(5)
rN–O(eclip) 1.201(3) 1.198(4) – 1.215(5)
rN–O(stag) 1.199(3) 1.178(5) – 1.222(4)
∡NCN_1 105.1(16) 108.2(3) – 110.9(3)
∡NCN_2 111.7(8) 107.3(3) – 111.4(2)
∡NCN_3 106.6(2) – 107.1(3)
∡ONO 129.2(17) 128.0(4) – 132.3(4)

Safety edit

The ability of TNM to detonate is greatly affected by the presence of impurities, even in small quantities. TNM forms extremely powerful explosive mixtures when fuels are added in stoichiometric proportions. Many of these mixtures show sensitivity to impact even higher than that of nitroglycerine.[14]

Tetranitromethane can be used as a component of highly explosive liquid explosives as an oxidizing agent. It forms highly explosive mixtures with all flammable substances. When experimenting with this substance, paper filters should not be used for filtration. Even small impurities make tetranitromethane an explosive that explodes on impact or friction. A tragic lecture experiment at the University of Münster in 1920 is well known, where a small steel tube containing tetranitromethane, toluene and absorbent cotton detonated shortly before burning out in such a way that more than 30 students were injured, some seriously;[15] however, on the basis of the rector's office records, as many as 10 deaths and more than a dozen injuries are documented.[16] Thereupon the German Chemical-technical Reichsanstalt determined a detonation speed of 9300 meters per second. Alfred Stettbacher then proved comparatively that this mixture was far more explosive than hexogen, pentrite, blasting gelatine or panclastite and thus represented the most destructive explosive of all.

TNM reacts with moisture at elevated pH to produce trinitromethane (nitroform) which reacts easily with metals to form highly unstable and explosive salts.[17]

Tetranitromethane is highly toxic. Absorption of as little as 2.5 mg/kg can cause methemoglobinemia, pulmonary edema, and damage to liver, kidney, and central nervous system. It is reasonably expected to be a human carcinogen.[18]

See also edit

References edit

  1. ^ Merck Index, 11th Edition, 9164.
  2. ^ a b c d NIOSH Pocket Guide to Chemical Hazards. "#0605". National Institute for Occupational Safety and Health (NIOSH).
  3. ^ "Tetranitromethane". Immediately Dangerous to Life or Health Concentrations (IDLH). National Institute for Occupational Safety and Health (NIOSH).
  4. ^ L. N. Shishkov (1857). "Sur la constitution de l'acetic fulminique et un nouvelle serie de corps derives de l'acide acetique". Annales de chimie et de physique. 49 (11): 310.
  5. ^ J. G. Tschinkel (1956). "Tetranitromethane as Oxidizer in Rocket Propellants". Industrial and Engineering Chemistry. 48 (4): 732–735. doi:10.1021/ie50556a022.
  6. ^ K. V. Altukhov, V. V. Perekalin (1976). "The Chemistry of Tetranitromethane". Russian Chemical Reviews. 45 (11): 1052–1066. Bibcode:1976RuCRv..45.1052A. doi:10.1070/RC1976v045n11ABEH002759. S2CID 250859816.
  7. ^ Liang, P. (1941). "Tetranitromethane" (PDF). Organic Syntheses. 21: 105; Collected Volumes, vol. 3, p. 803.
  8. ^ Mahoney vs Nitroform Co., 114 A.2d 863 (NJ Appellate Div 1955).
  9. ^ F. D. Chattaway (1910). "A simple method of preparing tetranitromethane". Journal of the Chemical Society. 97: 2099–2102. doi:10.1039/CT9109702099.
  10. ^ K. F. Hager (1949). "Tetranitromethane". Industrial and Engineering Chemistry. 41 (10): 2168–2172. doi:10.1021/ie50478a028.
  11. ^ K. J. P. Orton, P. V. McKie (1920). "The action of nitric acid on unsaturated hydrocarbons. The action of nitric acid on acetylene". Journal of the Chemical Society. 117: 283–297. doi:10.1039/CT9201700283.
  12. ^ Urbanski, Tadeusz (1964). Chemistry and Technology of Explosives. Vol. I. Pergamon Press. pp. 589–594. LCCN 83002261.
  13. ^ Vishnevskiy, Yury V.; Tikhonov, Denis S.; Schwabedissen, Jan; Stammler, Hans-Georg; Moll, Richard; Krumm, Burkhard; Klapötke, Thomas M.; Mitzel, Norbert W. (2017-08-01). "Tetranitromethane: A Nightmare of Molecular Flexibility in the Gaseous and Solid States". Angewandte Chemie International Edition. 56 (32): 9619–9623. doi:10.1002/anie.201704396. PMID 28557111.
  14. ^ Urbanski, Tadeusz (1964). Chemistry and Technology of Explosives. Vol. I. Pergamon Press. p. 593. LCCN 83002261.
  15. ^ Royal Society of Chemistry: Explosion Accident at the Chemical Institute, University of Munster i.W., and Its Cause. In: J. Chem. Soc., Abstr., 1920, 118, ii457-ii483. doi:10.1039/CA9201805457
  16. ^ Universitätsarchiv Münster, NU E I 9 spec., Explosionsunglück im Chemischen Institut am 27. Mai 1920, Rüst, A. Ebert, K. Egli: Unfälle beim chemischen Arbeiten. Rascher, 1948, S. 23.
  17. ^ Gakh, A. A.; Bryan, J. C.; Burnett, M. N.; Bonnesen, P. V. (2000). "Synthesis and structural analysis of some trinitromethanide salts". Journal of Molecular Structure. 520 (1–3): 221–228. Bibcode:2000JMoSt.520..221G. doi:10.1016/S0022-2860(99)00333-6.
  18. ^ National Toxicology Program (2011). "Tetranitromethane" (PDF). Report On Carcinogens (12th ed.). National Toxicology Program. Archived (PDF) from the original on 2013-01-31. Retrieved 2012-08-14.

External links edit

  • WebBook page for CN4O8
  • CDC - NIOSH Pocket Guide to Chemical Hazards