In mathematics, a wavelet series is a representation of a square-integrable (real- or complex-valued) function by a certain orthonormal series generated by a wavelet. This article provides a formal, mathematical definition of an orthonormal wavelet and of the integral wavelet transform.
for integers .
If under the standard inner product on ,
this family is orthonormal, it is an orthonormal system:
where is the Kronecker delta.
Completeness is satisfied if every function may be expanded in the basis as
The integral wavelet transform is the integral transform defined as
The wavelet coefficients are then given by
Here, is called the binary dilation or dyadic dilation, and is the binary or dyadic position.
The fundamental idea of wavelet transforms is that the transformation should allow only changes in time extension, but not shape. This is affected by choosing suitable basis functions that allow for this.[how?] Changes in the time extension are expected to conform to the corresponding analysis frequency of the basis function. Based on the uncertainty principle of signal processing,
The higher the required resolution in time, the lower the resolution in frequency has to be. The larger the extension of the analysis windows is chosen, the larger is the value of [how?].
When is large,
When is small
In other words, the basis function can be regarded as an impulse response of a system with which the function has been filtered. The transformed signal provides information about the time and the frequency. Therefore, wavelet-transformation contains information similar to the short-time-Fourier-transformation, but with additional special properties of the wavelets, which show up at the resolution in time at higher analysis frequencies of the basis function. The difference in time resolution at ascending frequencies for the Fourier transform and the wavelet transform is shown below. Note however, that the frequency resolution is decreasing for increasing frequencies while the temporal resolution increases. This consequence of the Fourier uncertainty principle is not correctly displayed in the Figure.
This shows that wavelet transformation is good in time resolution of high frequencies, while for slowly varying functions, the frequency resolution is remarkable.
Another example: The analysis of three superposed sinusoidal signals with STFT and wavelet-transformation.
Wavelet compression is a form of data compression well suited for image compression (sometimes also video compression and audio compression). Notable implementations are JPEG 2000, DjVu and ECW for still images, JPEG XS, CineForm, and the BBC's Dirac. The goal is to store image data in as little space as possible in a file. Wavelet compression can be either lossless or lossy.
Using a wavelet transform, the wavelet compression methods are adequate for representing transients, such as percussion sounds in audio, or high-frequency components in two-dimensional images, for example an image of stars on a night sky. This means that the transient elements of a data signal can be represented by a smaller amount of information than would be the case if some other transform, such as the more widespread discrete cosine transform, had been used.
Discrete wavelet transform has been successfully applied for the compression of electrocardiograph (ECG) signals In this work, the high correlation between the corresponding wavelet coefficients of signals of successive cardiac cycles is utilized employing linear prediction.
Wavelet compression is not effective for all kinds of data. Wavelet compression handles transient signals well. But smooth, periodic signals are better compressed using other methods, particularly traditional harmonic analysis in the frequency domain with Fourier-related transforms. Compressing data that has both transient and periodic characteristics may be done with hybrid techniques that use wavelets along with traditional harmonic analysis. For example, the Vorbis audio codec primarily uses the modified discrete cosine transform to compress audio (which is generally smooth and periodic), however allows the addition of a hybrid wavelet filter bank for improved reproduction of transients.
See Diary Of An x264 Developer: The problems with wavelets (2010) for discussion of practical issues of current methods using wavelets for video compression.
First a wavelet transform is applied. This produces as many coefficients as there are pixels in the image (i.e., there is no compression yet since it is only a transform). These coefficients can then be compressed more easily because the information is statistically concentrated in just a few coefficients. This principle is called transform coding. After that, the coefficients are quantized and the quantized values are entropy encoded and/or run length encoded.
For most natural images, the spectrum density of lower frequency is higher. As a result, information of the low frequency signal (reference signal) is generally preserved, while the information in the detail signal is discarded. From the perspective of image compression and reconstruction, a wavelet should meet the following criteria while performing image compression:
Wavelet image compression system involves filters and decimation, so it can be described as a linear shift-variant system. A typical wavelet transformation diagram is displayed below:
The transformation system contains two analysis filters (a low pass filter and a high pass filter ), a decimation process, an interpolation process, and two synthesis filters ( and ). The compression and reconstruction system generally involves low frequency components, which is the analysis filters for image compression and the synthesis filters for reconstruction. To evaluate such system, we can input an impulse and observe its reconstruction ; The optimal wavelet are those who bring minimum shift variance and sidelobe to . Even though wavelet with strict shift variance is not realistic, it is possible to select wavelet with only slight shift variance. For example, we can compare the shift variance of two filters:
|Wavelet filter 1||H0||9||.852699, .377402, -.110624, -.023849, .037828||1.068|
|G0||7||.788486, .418092, -.040689, -.064539||1.701|
|Wavelet filter 2||H0||6||.788486, .047699, -.129078||0.701|
|G0||10||.615051, .133389, -.067237, .006989, .018914||2.068|
By observing the impulse responses of the two filters, we can conclude that the second filter is less sensitive to the input location (i.e. it is less shift variant).
Another important issue for image compression and reconstruction is the system's oscillatory behavior, which might lead to severe undesired artifacts in the reconstructed image. To achieve this, the wavelet filters should have a large peak to sidelobe ratio.
So far we have discussed about one-dimension transformation of the image compression system. This issue can be extended to two dimension, while a more general term - shiftable multiscale transforms - is proposed.
As mentioned earlier, impulse response can be used to evaluate the image compression/reconstruction system.
For the input sequence , the reference signal after one level of decomposition is goes through decimation by a factor of two, while is a low pass filter. Similarly, the next reference signal is obtained by goes through decimation by a factor of two. After L levels of decomposition (and decimation), the analysis response is obtained by retaining one out of every samples: .
On the other hand, to reconstruct the signal x(n), we can consider a reference signal . If the detail signals are equal to zero for , then the reference signal at the previous stage ( stage) is , which is obtained by interpolating and convoluting with . Similarly, the procedure is iterated to obtain the reference signal at stage . After L iterations, the synthesis impulse response is calculated: , which relates the reference signal and the reconstructed signal.
To obtain the overall L level analysis/synthesis system, the analysis and synthesis responses are combined as below:
Finally, the peak to first sidelobe ratio and the average second sidelobe of the overall impulse response can be used to evaluate the wavelet image compression performance.
|Time-frequency analysis||time; frequency|
|Wavelet transform||scaling; time shift factor|
Wavelets have some slight benefits over Fourier transforms in reducing computations when examining specific frequencies. However, they are rarely more sensitive, and indeed, the common Morlet wavelet is mathematically identical to a short-time Fourier transform using a Gaussian window function. The exception is when searching for signals of a known, non-sinusoidal shape (e.g., heartbeats); in that case, using matched wavelets can outperform standard STFT/Morlet analyses.
The wavelet transform can provide us with the frequency of the signals and the time associated to those frequencies, making it very convenient for its application in numerous fields. For instance, signal processing of accelerations for gait analysis, for fault detection, for design of low power pacemakers and also in ultra-wideband (UWB) wireless communications.
Applied the following discretization of frequency and time:
Leading to wavelets of the form, the discrete formula for the basis wavelet:
Such discrete wavelets can be used for the transformation:
As apparent from wavelet-transformation representation (shown below)
where is scaling factor, represents time shift factor
and as already mentioned in this context, the wavelet-transformation corresponds to a convolution of a function and a wavelet-function. A convolution can be implemented as a multiplication in the frequency domain. With this the following approach of implementation results into:
Vorbis I is a forward-adaptive monolithic transform CODEC based on the Modified Discrete Cosine Transform. The codec is structured to allow addition of a hybrid wavelet filterbank in Vorbis II to offer better transient response and reproduction using a transform better suited to localized time events.
|Wikimedia Commons has media related to Wavelets.|