When it comes to Keiser m3i, calibration is needed when there is disassembly of the magnet assembly for some reason or there is replacement of the computer. This calibration method needs a special type of tool that Keiser supplies. All the steps have to be completed in only 30 seconds. After this period is over, the calibration mode will be exited by the computer. It needs to be allowed to sleep prior to calibration is attempted again. Find out how to calibrate Keiser m3i.
Turn off the PC
You can begin with your computer turned off. Next, you have to push the Resistance level to its lowest state.
Pedal a full revolution
Once you do that, you can find this “Time Row” value to be shown: M3 = “0:00”; M3i = “1”.
Place the calibration tool
You have to put the calibration tool onto flywheel, and slide up this tool until it stops hard under the magnet holder.
Put the magnets into the calibration tool
Then, you have to engage the magnets into this type of tool. Turn this tool in a counter-clockwise direction until there is stoppage of magnets against the Cal Tool cutouts. Get your magnet cover released and let it come back to the resting state. Remove the Cal Tool, as it is not needed anymore.
A full revolution will be pedaled, and this “Time Row” value would be shown: M3 = “0:01”; M3i = “2”.
Move Resistance Lever
You have to shift the Resistance Lever to stop 6 times from stop. Calibration will be successful.
Visit this website if you are interested for buying a spin bike for home.
