If your shark nv360 sucks, perhaps it is the sign telling you that it's time to empty and clean your vacuum cleaner. If you let the dirt cup overload, it can influence the performance, and the suction power isn't consistent. Below is how to empty and clean a Shark nv360 vacuum cleaner dirt cup:
When should you empty your machine's dirt cup?
Before going deeper into the details, you need to know when it's time to empty your vacuum cleaner. Any Shark nv360 machine has a line near the vacuum's top, and this "Max" or "Max Fill" mark indicates the level of dirt. You can wait until reaching the maximum acceptable level to empty, but it's better to empty this cup when it's half full.
Why?
The more dirt your machine vacuums, the lesser the power suction is.
Remember to empty the dirt cup anytime when your model loses the suction power and emits bad odors.
How to empty your machine's dirt cup
There are three steps, but all of them are very simple. Therefore, you don't have to be worried if you are a beginner user:
Step one: Unplug the vacuum cleaner from the power source.
Step two: Lift away the dirt cup from the whole model by sliding the dust cup release tabs at the cup's top.
If you want to open the dust cup from the bottom, let you press the lower release tab.
Step three: Empty this cup by holding it over a trash bin and pressing the release button.
After you are done, put your dust cup back into position and ensure that you close it in the right way.
How to clean your Shark vacuum cleaner dust cup
Actually, the cleaning process of cleaning your Shark navigator NV360 dust cup is straightforward. You just have to wash it under running water.
Remember to wash both inside and outside thoroughly and let it dry.
Before placing the dust cup back into the model, you should use a clean and dry piece of cloth to remove all water droplets.
Apart from the dirt cup, you also should clean these parts regularly for smooth performance:
How to clean your Shark vacuum filters
After removing the pre-motor filters from the machine, let you hand-wash them under cold running water until they clean thoroughly. Then, let your filters air dry for around one day and put them back into your vacuum cleaner.
It would be best if you cleaned the pre-filters at least once a month.
How to clean Shark NV360 brush rolls
Before cleaning, you need to separate the floor attachment from the handle, then remove the brush roll garage by pressing 2 buttons at each end of the floor attachments. Don't forget to cut all hairs and strings wrapped around the brush roll with a pair of scissors.
Remove debris from the bristle brush and soft roller. In case they are too dirty, you can clean them with water and let them air dry in 24 hours.
Actually, it’s effortless to clean and empty the dirt up as well as other parts of your shark nv360k navigator lift-away deluxe professional bagless vacuum. You simply have to remove the parts, clean them under the water, let them air dry, and put them back.
Source: https://offshorecitizen.net/forum/profile/markbolton/
See Page:
Shark Navigator Lift-Away Deluxe NV360
Frequently asked questions about Shark NV360
Shark navigator lift away deluxe nv360 - shark navigator nv360
