I don't know about you, but working on creating projects with the right tools makes all the difference. Especially saved time. One of the best tools available in your tool kit is a quality air compressor. Like many things, choosing the right one is important not only for performance, but also for your safety. Make sure you understand the following points before purchasing and do not forget to get professional help from Universal plant services.
Rotary and Reciprocating Air compressors
The most common compressors are reciprocating compressors. The simple design of the piston makes them easy to manufacture, which means savings for you. The piston is used to raise the pressure inside the cylinder and store it in the holding container. Rotary compressors are much more complex and work in a completely different way. The pressure is created by two helical screws that rotate in a closed chamber. The larger the rotary compressors, the more efficient they will be. If size is the driving factor in your situation, switch to a reciprocating air compressor.
Duty Cycle
If you need to keep the compressor running continuously, like spray painting, choose a rotary air compressor. Reciprocating air compressors are ideal for air appliances where pressure is used frequently and in short bursts. Rotary compressors exhibit a 100% duty cycle and the interlock is typically 50%, which means that 50% of the new pressure must build up over time.
Power Type
The most common types of power options are diesel or electric. Deciding which one is right for your situation is largely determined by the environment in which your air compressor must operate. Diesel compressors can work for the long term. Despite their large production capacity, they are portable, making them a favorite in the construction industry. Although diesel fuel is available even in remote locations, adequate ventilation is required, limiting its use outdoors.
Noise
Basically the bigger the air compressor, the louder the noise. Reciprocating air compressors are typically smaller and run at 50% duty cycles, as these portable devices shouldn't face too many problems. However, devices with large volumes of diesel fuel during construction will need to be evaluated for environmental noise pollution during construction. Permanently mounted parts will require a special engine room with some areas requiring acoustic control.
Portability
Obviously, the smaller reciprocating units can easily be thrown into the back of your vehicle. The larger diesel fuel is equipped with a traction device, but they are heavier parts for traction. The choice of your vehicle is very important here. Be sure to check the maximum traction load of the vehicle.
PSI
This is a universal rating for the amount of pressure produced. You will need to evaluate the optimal pressure head of the equipment using a compressor. Also, if your equipment needs a constant or intermittent pressure flow. Most hand tools require approximately 90 psi, so choose a compressor with a lift limit of approximately 110 psi, which will allow the line to shut down. In fact, the more you use devices connected to an air compressor, the more pressure it will need.
Conclusion
For most homeworkers like myself, a small portable reciprocating air compressor is usually sufficient. Put the air pistol in and you're gone. Matching the right air compressor with the right tools for the job will make a significant difference to the speed and build of your next project.
